Forgot to say, its looking good!
From: Phil <
This email address is being protected from spambots. You need JavaScript enabled to view it.>
To:
This email address is being protected from spambots. You need JavaScript enabled to view it.
Sent: Wednesday, June 19, 2013 6:22 AM
Subject: [Carbondragonbuildersandpilots] Phil's Carbon Dragon - progress...
Hi Folks,
Just thought you might like to see a short video of part of one of the leading edge mould plugs being fabricated.
I did try another method of making the moulds first (lining 'negative' formers with a sheet of 0.5mm polycarbonate) but I couldn't get the polycarbonate sheet to conform perfectly to the formers no matter how hard I tried! So... I reverted to using the old, tried and tested method of gluing blocks of polyurethane foam between 'positive' rib formers and sanding... sanding... sanding..!
I hope to cover the polyurethane plug I just made with fiberglass this weekend and perhaps even lay-up the carbon fiber in the new mould next week if all goes well.
Enjoy,
Phil.