Thanks Yasushi.
Now I understand how the hinges are assembled. I was under the mistaken impression that the male hinges actually went between the flanges of the female hinges.
--- In This email address is being protected from spambots. You need JavaScript enabled to view it., "akahori" wrote:
>
> Now I am uploading 3 pictures in my photo holder, Please look it.
>
> Is it OK??
>
>
> Yasuhsi Akahori
>
Original Message
> From: Dewey
> To: This email address is being protected from spambots. You need JavaScript enabled to view it.
> Sent: Thursday, February 02, 2012 12:15 PM
> Subject: [Carbondragonbuildersandpilots] Re: Tail surface hinge assembly
>
>
>
> Thanks Yasushi but I need a photo of how the rudder is installed. How are
> the pivot bolts installed? It is not clear as to how much room there is to
> install the pivot bolts.
>
> --- In This email address is being protected from spambots. You need JavaScript enabled to view it., "akahori"
> <fledge@> wrote:
> >
> > Now I am uploading my file to photoalbum. wait a moment.
> >
> >
> >
Original Message
> > From: Dewey
> > To: This email address is being protected from spambots. You need JavaScript enabled to view it.
> > Sent: Thursday, February 02, 2012 10:03 AM
> > Subject: [Carbondragonbuildersandpilots] Re: Tail surface hinge assembly
> >
> >
> >
> > Yasushi,
> > can you provide a photo of the hinge in its assembled state?
> >
> > --- In This email address is being protected from spambots. You need JavaScript enabled to view it., "akahori"
> > <fledge@> wrote:
> > >
> > > I am assembled without a problem. I must not cut an obstacle?
> > > The reason why I sew it with carbon will be that I reduce weight.
> > >
> > >
> > > Yasushi Akahori from Japan
> > >
> > >
> > >
Original Message
> > > From: Dewey
> > > To: This email address is being protected from spambots. You need JavaScript enabled to view it.
> > > Sent: Thursday, February 02, 2012 9:14 AM
> > > Subject: [Carbondragonbuildersandpilots] Tail surface hinge assembly
> > >
> > >
> > >
> > > Can anyone explain how to assemble the rudder to the vertical stab
> once
> > > the airplane is finished? I can't see how one would insert and fasten
> > the
> > > pivot bolts through the hinges. Would not the gap covers interfere
> with
> > > assembly? Also, why not bolt the hinges to the spars instead of the
> > "sewing"
> > > with roving? This seems gimmicky.
> > > The same applies for the elevator and horizontal stab as well. Photos
> > > would be nice.
