Thanks Yasushi but I need a photo of how the rudder is installed. How are the pivot bolts installed? It is not clear as to how much room there is to install the pivot bolts.
--- In This email address is being protected from spambots. You need JavaScript enabled to view it., "akahori" wrote:
>
> Now I am uploading my file to photoalbum. wait a moment.
>
>
>
Original Message
> From: Dewey
> To: This email address is being protected from spambots. You need JavaScript enabled to view it.
> Sent: Thursday, February 02, 2012 10:03 AM
> Subject: [Carbondragonbuildersandpilots] Re: Tail surface hinge assembly
>
>
>
> Yasushi,
> can you provide a photo of the hinge in its assembled state?
>
> --- In This email address is being protected from spambots. You need JavaScript enabled to view it., "akahori"
> <fledge@> wrote:
> >
> > I am assembled without a problem. I must not cut an obstacle?
> > The reason why I sew it with carbon will be that I reduce weight.
> >
> >
> > Yasushi Akahori from Japan
> >
> >
> >
Original Message
> > From: Dewey
> > To: This email address is being protected from spambots. You need JavaScript enabled to view it.
> > Sent: Thursday, February 02, 2012 9:14 AM
> > Subject: [Carbondragonbuildersandpilots] Tail surface hinge assembly
> >
> >
> >
> > Can anyone explain how to assemble the rudder to the vertical stab once
> > the airplane is finished? I can't see how one would insert and fasten
> the
> > pivot bolts through the hinges. Would not the gap covers interfere with
> > assembly? Also, why not bolt the hinges to the spars instead of the
> "sewing"
> > with roving? This seems gimmicky.
> > The same applies for the elevator and horizontal stab as well. Photos
> > would be nice.
